



Specification


2K DGUS module | DWIN independently developed, A Core module powered by the T5L2 ASIC,running DGUS II HMI platform |
User interface | 8Pin_2.0mm socket for power supply and serial communication |
Flash | 32MBytes (2*16MBytes NOR Flash), can be used to store user UI files such as fonts, images, music, etc., with erase/write cycles >100,000 times |
Expand Flash pads | Two expansion slots support NOR or NAND Flash, up to 64MB(4x16MB NOR Flash) or 48MB+512MB (3x16MB NOR Flash + 512MB NAND Flash) |
Buzzer | 3V passive buzzer |
Speaker interface | 2Pin_2.0mm socket, speaker interface |
RTC | Super-capacitor supplies power to RTC, accuracy: ±20ppm @25℃. Can maintain normal operation for 7 days after power-off. Reserved button cell power supply compatible circuit. |
SD card slot | For DGUS project file downloads (UI, CFG files, kernel, etc.), 4 Mb/srate |
Reserved module interface | Supports DWIN Wi-Fi modules (e.g., Wi-Fi-20) and USB download modules(e.g., HDL702) |
PGT05 interface | For programming DGUS firmware, located inside the shield of 2K DGUS module |
LCD Type | IPS, TFT LCD |
Viewing Angle | Wide viewing angle (typical values are 85°/85°/85°/85°), high contrast, and good color reproduction |
Resolution | 1920×1080 pixels (0°/90°/180°/270°) |
Color | 24-bit 8R8G8B |
Active Area (A.A.) | 382.89mm (W)×215.81mm (H) |
Backlight Mode | LED |
Backlight Service Life | >20000 hours |
Brightness | DMG19108C173_05WTC:200nit DMG19108C173_05WN:250nit |
Brightness Control | 100-level brightness adjustment (Flickering may occur at 1%-30%of max brightness; not recommended for use in this range) |
Note: Use dynamic screen saver to prevent afterimages from prolonged fixed page display. |
Mode | UART2: ON=TTL/CMOS; OFF=RS232 | |||||
Voltage Level | Test Condition | Min | Typ | Max | Unit | |
Output 1, Iout = -4mA | 4.78 | 5.0 | - | V | ||
Output 0, Iout = 4mA | - | - | 0.4 | V | ||
Input 1 | 2.5 | 5.0 | - | V | ||
Input 0 | - | - | 1.0 | V | ||
Baud Rate | 3150~3225600bps, typical value of 115200bps | |||||
Data Format | UART2: N81 |
|||||
Interface Cable | 8Pin_2.0mm |
Rated Power | <10W | |||||
Operating Voltage | 12~36V, typical value of 12V | |||||
Operating Current | 720mA | VCC=12V, max backlight | ||||
180mA | VCC=12V, backlight off | |||||
Recommended power supply: 12V 1A DC |
Operating Temperature | 0℃~50℃ (12V @ 60% RH) | |||||
Storage Temperature | -20℃~60℃ | |||||
Conformal Coating | None | |||||
Operating Humidity | 10%~90%RH, typical value of 60% RH |